HarleyTechTalk

I like the Tapered Gaskets



and I'd replace the exhaust studs with the M8 studs

Part # 10900015A HD OEM

Quote from: kd on April 22, 2024, 06:58:08 AMTry a search on this site.  IIRC Ohio HD has posted the gear ratio you may need.  The input "codes" can depend on the tuning device you use.

The tool that Dyno Jet sent to me makes a calculation based on the two transmissions gear ratio differences, and also against the MAP gear ratios for that bike. Not all MAP gear ratios are the same for an OEM six speed, I've seen them change by different year bikes. So unless he has a PV or TTS now, I don't know how you would adjust the ratios and hopefully the speedometer to match the GB transmission.

This is what the spreadsheet looks like from Dyno Jet. I assume this would work for TTS as well, but I don't know that for a fact.

It doen't matter which gasket you use .The tapered ones seem to seal better , but could interfere with the port when tighten down. The strait ones will eliminate the port interference but they could leak .

That's crazy!

thanks

The Baker instructions that would have been sent with the transmission discuss the need to introduce your motorcycle to the new Grudgebox ratios if you want cruise control. You can go to their website for more information if you need to.

The GrudgeBox transmission is 250 RPM overdrive in 6th gear.  If your cruise will engage in 5th gear, the system is working.  For now while waiting to remedy it (or ever if you wish) set cruise in 5th gear and shift without the clutch into 6th.  By not disengaging the clutch with the clutch lever, you trick cruise into staying engaged.

Try a search on this site.  IIRC Ohio HD has posted the gear ratio you may need.  The input "codes" can depend on the tuning device you use.

Should read atmospheric pressure (~100KPA) at key on, engine off, 60ish during cranking, transitioning to 30ish KPA @ idle.

  I have a warranted claim from a dealer for changing one and the charges out were 16 hours. That was on a Street Glide.

07 dyna twincam map sensor reading while cranking over at start up. And idling . 

Quote from: FXDBI on April 21, 2024, 10:01:37 PMFor interest sake anyone know what the flat rate hours is to change out the gear cassette on a 2008 Electra glide?  Thanks Bob

The closest info that I have is labor code 4366. Replace main drive gear and/or bearing 3.4 hours.

To change the main drive bearing of course the cassette comes out. And most transmission swaps would include the main drive gear and a new bearing. If not, probably knock about 1.0 or 0.7 hours off.