Author Topic: help me on dimensions for a TOOL  (Read 306 times)

0 Members and 1 Guest are viewing this topic.

Offline evo58

  • Full Member
  • Posts: 724
help me on dimensions for a TOOL
« on: December 28, 2017, 10:26:09 AM »
Hi all,

i need to do a Fxsts springer front end desassemble tool, its a  5/16  rod, but couldnt find the sizes for the block, anyone has these dimensions , plus the long 1/2 hex nut ?????
thanks in advance
evo

Offline PoorUB

  • Site Supporter
  • Full Member
  • *****
  • Posts: 13950
  • Country: us
  • Tropical Fargo, ND
Re: help me on dimensions for a TOOL
« Reply #1 on: December 30, 2017, 11:42:57 AM »
As for the long nut, look for a threaded rod coupling nut.
« Last Edit: December 30, 2017, 12:36:57 PM by PoorUB »
I am an adult?? When did that happen, and how do I make it stop?!

Offline Ajayrk

  • Site Supporter
  • Full Member
  • *****
  • Posts: 1364
  • Country: us
Re: help me on dimensions for a TOOL
« Reply #2 on: December 30, 2017, 12:32:58 PM »
I made one to these dimensions:

1.045 long X .75 wide x .839 high.  .395 hole drilled through the .839 side on center of .397 from the edge.
Drilled and tapped the other end for 5.16" all thread.  Coupling nut for rod and a large diameter waser.  I'll try to get a picture.
AJ

Offline Ajayrk

  • Site Supporter
  • Full Member
  • *****
  • Posts: 1364
  • Country: us
Re: help me on dimensions for a TOOL
« Reply #3 on: December 30, 2017, 01:22:32 PM »
rod
AJ