Author Topic: LED Drivers question  (Read 253 times)

0 Members and 1 Guest are viewing this topic.

Offline Latrobedyna

  • Full Member
  • Posts: 721
  • Country: us
LED Drivers question
« on: October 28, 2017, 09:40:20 AM »
You folks that deck out your bikes with LED'S. Do you use LED driver circuits to drive the LED'S?
Next question. I am assuming that a current based driver would be the proper type if you do use any.
Thank you very kindly in advance for any and all replies. Jeff 
2006 FXDB , 95" 57H +4% cam, 10:25 pistons: Ported head's. Lots a fun

Online FurryOne

  • Site Supporter
  • Full Member
  • *****
  • Posts: 233
  • Country: us
Re: LED Drivers question
« Reply #1 on: October 28, 2017, 05:23:39 PM »
You folks that deck out your bikes with LED'S. Do you use LED driver circuits to drive the LED'S?
Next question. I am assuming that a current based driver would be the proper type if you do use any.
Thank you very kindly in advance for any and all replies. Jeff

Wait a minute - I was blinded by those "headlights!"  Most of the LED strips available for bikes run directly off the 12 volts and have resistors built-in.  They'll usually say what their voltage requirement is.