Author Topic: DynoJet: Changing PowerVision VE values.  (Read 266 times)

0 Members and 1 Guest are viewing this topic.

Offline Harley Pilot

  • Member
  • Posts: 29
Changing PowerVision VE values.
« on: January 14, 2018, 08:12:44 PM »
Is there a way to change the VE values in increments like you can in the SERT? Im talking like hightlighting the cell and increase or decrease with out have  to enter the actual value?

Thanks,

Offline Coyote

  • HTT Janitor
  • Administrator
  • Full Member
  • *****
  • Posts: 12428
  • Country: us
  • The foothills of northern CA
Re: Changing PowerVision VE values.
« Reply #1 on: January 14, 2018, 08:16:53 PM »
Just put the increment value in the box and hit add or subtract
I feel the need... for twisties with speed.

Offline Harley Pilot

  • Member
  • Posts: 29
Re: Changing PowerVision VE values.
« Reply #2 on: January 14, 2018, 08:27:44 PM »
Thanks, so can you highlight multiple cells or do you have to do one cell at a time?

Offline Coyote

  • HTT Janitor
  • Administrator
  • Full Member
  • *****
  • Posts: 12428
  • Country: us
  • The foothills of northern CA
Re: Changing PowerVision VE values.
« Reply #3 on: January 14, 2018, 09:14:40 PM »
You can do either
I feel the need... for twisties with speed.

Offline Harley Pilot

  • Member
  • Posts: 29
Re: Changing PowerVision VE values.
« Reply #4 on: January 15, 2018, 05:06:32 AM »
Thanks, Iím new at the PowerVision and I appreciate your help. Is there any atvantage to changing the enable/disable points for the PE, also Iím using a SERT base map set up for CVO cams should I be concerned with the crank tooth setting seeing as Iím running the 551 cams?

THANKS AGAIN!! :SM: