Author Topic: SE Pro Super Tuner 32109-08A no connection with M8 ECM  (Read 257 times)

0 Members and 1 Guest are viewing this topic.

Offline Heritage_100

  • Member
  • Posts: 9
SE Pro Super Tuner 32109-08A no connection with M8 ECM
« on: February 02, 2018, 10:56:07 AM »
I have a  2018 FLTRXS that does not have connection with the SEPST program using SE pro super Tuner 32109-08A. There  can be connection  with newer VCI 32109-08C. The 08A version is making connection with the older bikes, I tested 2008 and 2012 touring bikes, which have 4-pin connector.
Can there be a programmed block preventing 32109-08A connection to M8 engine? 6-PIN  cable is good. Both modules are having the latest firmware (414). 32109-08A is never paired with an ECM.

Offline Scotty

  • Full Member
  • Posts: 652
  • Country: au
Re: SE Pro Super Tuner 32109-08A no connection with M8 ECM
« Reply #1 on: February 02, 2018, 01:48:08 PM »
If the 32108-08A is one of those refurbished ones where they have reset the flash then it will not work with a 6 pin bike no matter what you do.

If however it is just NOS (new old stock) and has never been used then it should work but I don't have a 2018 bike here to test but I have had them hooked up to a 2017