Hydrolic conversion cams for 88”

[838]

Which companies make these conversion cams regularly..  not a "special order?"

[hattitude]

Which companies make these conversion cams regularly..  not a “special order?”

I used Andrews conversion cams (26N), and I was considering Woods conversion cams (TW-6-6 R), in my 88 with a big bore kit (95ci)....

The Andrew's conversion cams end with an "N" in the part number and the Wood's conversion cams end with an "R" in the part number

Those conversion cams are readily available...

[838]

I'll get a little more specific.... we're  something similar to a tman .590.. woods 8?

[Ranze]

I have Andrews 31 N on my 88 ->106" stroker. Near Andrews 37, but gives power less rews. Feuling supportplate & pump. Not driven yet, we have winter here.

[Herko]

N Series Cam Specs:
http://www.andrewsproducts.com/sites/www.andrewsproducts.com/files/catalog_pdfs/page_07_0.pdf

[838]

Fueling also makes them. Would the .594 be similar similar to the others that I've mentioned?

[DTTJGlide]

The 594s needs a lot more CR with their 56* intake close, the Andrews 55s are a lot closer, just a little less lift @ .550 you could always put stilts on the intakes.

[838]

The 594s needs a lot more CR with their 56* intake close, the Andrews 55s are a lot closer, just a little less lift @ .550 you could always put stilts on the intakes.

👍. Didn't even look at the intake close of the .594... probably great if doing 11.25:1 or so though...