fault codes for 2009 Touring

[Tynker]

Can someone direct me to the list of codes that will help me find the problem with a friends bike, It was running fine, the on his way to Austin, TX. it started spurting , hard to take off from a stop. and sometimes surging going down the highway. I am thinking twist grip modual, or TPS.

[Chippitt68]

Fuel Moto has all trouble codes on their website

[Ohio HD]

Nyet, HTT has them.


Priority/DTC/Fault condition

HFSM= Hand Free Security Module
TSM= Turn Signal Module

P0605-ECM Flash memory error
P0603-ECM EEPROM memory error
U1300-ECM serial data low
U1301-ECM serial data high
U1097-Loss of speedometer serial data to ECM
U1064-Loss of TSM/FSFM serial data to ECM
P1001-System relay coil open/low
P1002-System relay coil high/shorted
P1003-System relay contacts open
P1004-System relay contacts closed
P1009-Incorrect password
P1010-Missing password
P06415-V+Vref 1 out of range
P06515-V+Vref 2 out of range
P0373-CKP sensor intermittent
P0107-Map sensor open/low
P0108-Map sensor high
P0374-CKP sensor synch error
P1511-Throttle actuator control power management failure of throttle control actuator
P1600-EFI module processor internal error
P1270-TGS validation error
P2107-EFI module processor internal fault
P2101-Throttle actuator control motor circuit range/performance error
P2122 -TGS1 low/open
P2123-TGS1 high
P2127-TGS2 low/open
P2128-TGS2 high
P2138-TGS correlation error ( Twist Grip Sensor )
P0120-TPS1 range error
P0122-TPS1 low
P0123-TPS2 high/open
P0220-TPS2 range error
P0222-TPS2 low
P0223-TPS2 high/open
P2135-TPS correlation error
P2119-EFI motor throttle body range performance
P2100-EFI motor circuit low
P2101-EFI motor circuit range performance (Actuation Error)
P2102-EFI motor circuit low
P2103-EFI motor circuit high
P2176-EFI closed position not learned
P1514-Air flow fault
P2105-EFI forced engine shutdown
P1501-Jiffy stand sensor low
P1502-Jiffy stand sensor high
P0572-Brake switch low
P0117-ET sensor low
P0118-ET sensor high
P01121-AT voltage low
P01131-AT voltage open/high
P1351-Front ignition coil driver open/low
P1352-Front ignition coil driver high/shorted
P1354-Rear ignition coil driver open/low
P1355-Rear ignition coil driver high/shorted
P1357-Front cylinder combustion intermittent
P1358-Rear cylinder combustion intermittent
P0261-Front injector open/low
P0262-Front injector high
P0263-Rear injector open/low
P0264-Rear injector high
P0562-Battery voltage low
P0563-Battery voltage high
P0501-VSS sensor low
P0502-VSS sensor high/open
P1356-Rear cylinder no combustion
P1353-Front cylinder no combustion
P0444-Purge solenoid open/low
P0445-Purge solenoid high
P1475-Exhaust actuation position error
P1477-Exhaust actuator open/low
P1478-Exhaust actuator high/shorted
P0131-Front oxygen sensor low
P0132-Front oxygen sensor high
P0134-Front oxygen sensor inactive
P0151-Rear oxygen sensor low
P0152-Rear oxygen sensor high
P0154-rear oxygen sensor inactive
P1510-EFI limited performance mode
P1511-EFI power management mode
P1512-EFI forced idle mode
P0577-Cruise control input high
U1300-Serial data low
U1301-Serial data high
U1016-Loss of ECM serial data
U1255-Serial data error
B1142-Smart security system internal fault
B1135-Accelerometer failed
B1136-Accelerometer tip test error (HFSM)
B1151-Bank angle sensor short to ground
B1152-Bank angle sensor short to battery
B1153-Bank angle sensor high
B1154-Clutch switch input short to ground
B1155-Neutral switch input short to battery
B1134-Starter output high
B1121-Left turn output fault (TSM) or left turn output open (HFSM)
B1122-Right turn output fault (TSM) or right turn output open (HFSM)
B1123-Left turn output short to ground (HFSM)
B1124-Right turn output short to ground (HFSM)
B1125-Left turn output short to battery (HFSM)
B1126-Right turn output short to battery (HFSM)
B1143-Security antenna short to ground (HFSM)
B1144-Security antenna short to battery (HFSM)
B1145-Security antenna open (HFSM)
B0563-Battery voltage high
B1131-Alarm output low (HFSM)
B1132-Alarm output high (HFSM)
B1141-Ignition switch low/open (TSM/HFSM)

The following codes are from a 08 diagnostics manual for bikes with ABS

C0562-Device voltage low
C0563-System voltage high
C1014-ECU internal fault
C1017-Pump motor power circuit open fault
C1018-Pump motor ground high resistance fault
C1021-Front wheel speed sensor equals 0
C1027-Rear wheel speed sensor equals 0
C1025-Front wheel speed signal intermittent
C1027-Rear wheel speed signal intermittent
C1032-Front wheel speed sensor circuit open/shorted
C1034-Rear wheel speed sensor circuit open /shorted
C1042-pump motor open
C1043-Pump motor stalled
C1055-ECU internal fault
C1056-ECU internal fault
C1057-ECU internal fault
C1061-ECU internal fault
C1062-ECU internal fault
C1065-ECU internal fault
C1066-ECU internal fault
C1118-ECU internal fault
C1121-ECU internal fault
C1094-Front brake switch always on
C1095-Front brake switch open
C1151-Front wheel release too long
C1153-Rear wheel release too long
C1158-Calibration programming required
C1206-Wheel speed sensor frequency out of range
C1208-Wheel speed sensor frequency out of range
C1212-Front or rear brake not applied with decel
C1214-Rear brake switch always on
C1216-Rear brake switch open

[Tynker]

Thanks, that is just what I needed.