Will 2015 Street Glide tin fit on a 1994 Road king?

Started by thumper 823, June 04, 2019, 04:16:34 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

thumper 823

Thanx !
Not too bad and a heck of a lot cheaper than a paint job!
D Troop 3/5, - C/16 ,162AHC, Mekong delta.
Rising from the Ashes  UHIH

PoorUB

Interesting project, but I would not call it a "bolt on". My definition of bolt on is if the part fits with no mods, so I guess it depends how far you want to stretch the definition. Actually surprised much of it fit as easily as it did.
I am an adult?? When did that happen, and how do I make it stop?!

thumper 823

D Troop 3/5, - C/16 ,162AHC, Mekong delta.
Rising from the Ashes  UHIH

Tacocaster

Thumper? Did you work-in the newer (wider) rear section last winter?
Curious how that went, if done but I'm pretty confident like you, it would be a no-brainer to install.
We're all A-holes. It's to what degree that makes us different.

Tacocaster

Good of you to offer thumper but thanks, no. I was just curious.

I have an 07 FLHX and always thought the stock real sneaker was too narrow. I do like the look of the 200 sneaker out back but think the Aftermarkets kits are too expensive for this kid. So after reading your thread and following your lead, I made a high level pass to see what would be involved. I seen a number of "supporting role" parts that would need to be acquired around the fender supports/fender/wheel/axle/etc/etc/etc and simply wrote off any further investigation.
I've lived with the 150 this long, what's another.....?

I do like what you've done to your King though! If ya don't try....
We're all A-holes. It's to what degree that makes us different.

thumper 823

I used the same mounts for the bags and trunk that I had on B4 the change
The trunk-mount needed some "adjustment"  but the bags,- again were just bolt-on like most everything else.
When I say bolt-on "some slight adjustments were neccessery.
Not hard at all, unless this is your first adventure
D Troop 3/5, - C/16 ,162AHC, Mekong delta.
Rising from the Ashes  UHIH


thumper 823

Thanx!
Thanx to all who appreciate a little project.
I was simpler than painting.
D Troop 3/5, - C/16 ,162AHC, Mekong delta.
Rising from the Ashes  UHIH

thumper 823

February 10, 2021, 12:38:50 AM #33 Last Edit: February 10, 2021, 12:48:45 AM by thumper 823
Next little project....  (in addition to the tin work)
Anyone else do this ?-
The Next mod here will be floorboards and rear master cylinder
from the newer generation too.
Fat Boy parts and such bolt-on from the outside rather than from underneath which are a PIA!
The Master cylinder underneath with the remote reservoir is not user friendly!
Every time i need to drop the exhaust or cam cover  (which is way too often)  the right side floorboard
needs to be removed.
If you have ever had to do this you feel my pain.
I am just trying to make things simpler.
D Troop 3/5, - C/16 ,162AHC, Mekong delta.
Rising from the Ashes  UHIH