P0261

[China twin 88]

692-1631cl throwing code PO261 after install on 2018fltrxs... if the furl processor is taken off .. the bike runs fine. 

[rigidthumper]

The Cobra unit is changing the resistance to the front injector path; enough so that it's seen as a fault.

[China twin 88]

@rigidthumper, thanks .... I have little knowledge of cobra, is there a way to sort this? i have asked was there any changes or different material, shorter/longer wires, or changed the conductor...

[rigidthumper]

The Cobra unit is an inline device. (captures/modifies signals to/from the ECM) Occasionally, there will be a loose pin connection that causes this- check the individual pins fit & crimp on the Cobra harness.  If all pin connections are tight, then it's likely a bad solder joint on the circuit board.

[China twin 88]

thanks greatly