Baker tapered main bearing kit ?

[Tattoo]

anybody use this kit with there factory six speed?

[jmorton10]

How much power are you putting into that factory 6 speed??

I have that Baker bearing in my 124 now, but only after I ripped 6 teeth off 3rd gear in the stock tranny & replaced it with an entire Baker tranny.

~John

[Tattoo]

mild build but do a lot of miles a year.

[kd]

I think if you look at the cost, and you have to do yours because of a failure, the cost becomes only the difference in what you have to spend any way.  My only experience is with my grudge box but they sure look beefy and the set-up is very fine when it comes to clearances.  That says more control and less wear to me.

[D-1]

Ive put a couple in stock gearboxes after the stock output bearing failed early. One was around 20,000mi and the other was earlier. Nice and strong, but have to be set up right.

[les]

I installed the Grudge Box bearing in my stock H-D cruise drive six-speed.  I've got a 124".  It lasted about 20K miles before the seal between the pulley spacer and the large bearing seal started leaking.

I now have the Grudge Box transmission, and of course the Grudge Box bearing.  So, I've both installed and removed those bearings.

[boooby1744]

Local shop uses a ceramic hybrid from Worldwide Bearings.

[Latrobedyna]

Local shop uses a ceramic hybrid from Worldwide Bearings.

Do you have a part # ?

[boooby1744]

Local shop uses a ceramic hybrid from Worldwide Bearings.

Do you have a part # ?

It was a Facebook post from SLNYC. No part number was mentioned.Give Worldwide a call.

[les]

Local shop uses a ceramic hybrid from Worldwide Bearings.

Do you know if that shop uses ceramic bearings for the Timken style sprocket shaft bearings in the engine too?

[boooby1744]

Local shop uses a ceramic hybrid from Worldwide Bearings.

Do you know if that shop uses ceramic bearings for the Timken style sprocket shaft bearings in the engine too?

I don't think so.