2014 compression ?

[topcat3815]

Have a 2014 limited wet head I am installing a set of street port heads on, the pistons are down in the hole .008, the heads have 83cc volume and I  have a cyclerama 570 cam with 32 degrees intake closing. I am going with a cometic .036 HG  It should have 10.8 static and 9.57 corrected comp. Im using a power vision tuner with target tune. Is this to much corrected compression for the street ?

[rigidthumper]

Question-Do you have domed pistons?
If you are running the flat tops that came with that bike, you're at ~10:1 static, and that compression is not an issue, given an adequate tune..

[topcat3815]

The pistons are stock flat tops

[rigidthumper]

You can enter the figures you have here, and see the effects on compression.
I would use .030" head gaskets and get a good tune, and run the snot out of it

[topcat3815]

Thanks I have been using Big Boyz calculator, after rechecking the deck height it is .007 on both pistons, if I go with this cam with the in. closing at 32 degrees Ill have 10.21 static and 9.70 corrected with a .030 HG and with a .036 HG 10.10 static and 9.59 corrected. I also have a Torqster 555 that has the in. closing at 37 degrees this cam will give me  10.21 static and 9.53 corrected with a .030 HG and 10.10 static and 9.42 corrected with a .036 HG. Decisions and Thanks for all replies

[PoorUB]

Easy answer. CR570 and .030" head gasket.  I don't  even have to think about it other than I might mill a touch off the heads. Pretty sure you can bump that compression  a bit higher with no worries.

[harley#1]

hey topcat. wonder what a cr575 would do in your build. it like a little compression.

[topcat3815]

I was considering the cr 575, so I called wes at cr and asked him he said that he would go with the cr570 with my setup.