Rinehart 2 into 1 exhaust

[PJultra]

i just got my new exhaust. Part #200-0104. 98 Ultra Classic
Rinehart site says will fit 95-2008.
But the trans mount isn't right. Or is there something I'm missing? My old exhaust was clamped to the tranny bracket. This has flat plate sticking out that has a bolt hole in it welded to the exhaust.
Going to try and post a pic..

[hbkeith]

look at the installation intructions on there site ?

[kd]

What size are the O2 bungs?   The early (98) had no O2 sensors and that was followed by the 07 to 09 18 mm usually up near the exhaust ports.  The 12 mm were in the position your pic shows but were 2010 up.  You may not have what you think.

[rigidthumper]

Did it come with a replacement trans bracket? IIRC, you had to remove the one that clamps to the pipe with a "bent triangle" bracket.

[rigidthumper]

Or maybe something like this?

[PJultra]

Did it come with a replacement trans bracket? IIRC, you had to remove the one that clamps to the pipe with a "bent triangle" bracket.

No. But after looking around on the web, the last year for that type of bracket was 06.
When I go to Rinehart, it shows that part # is for 95-2008. I think that is supposed to be 95-2006.

[PJultra]

I found it. I need the 200-0190 bracket. Just emailed Rinehart,
Thanx for the responses.

[hbkeith]

I found it. I need the 200-0190 bracket. Just emailed Rinehart,
Thanx for the responses.