Using MegaLogViewer To Develop TTS VE Tables?

Started by Fritzables, December 07, 2020, 02:17:58 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Fritzables

I have recently purchased MegaLogViewer to assist in developing my TTS VE Tables amongst other tables.

I have attached a screen shot of the LogViewer Tab of one of the datalogger runs I have done recently:

[attach=0]

In this scenario, I want to concentrate on the Idle, to make sure all is as it should be. I have selected a range and the table at the bottom right displayed the detail for the selected portion.
The Desired Lambda is 0.940 at Idle, so I would expect the O2 Sensor voltage should be around 825 mV.

So, I can take a look at the table at the bottom right and see if the average is around 825mV and if it's out by by more than say 5% I can then adjust me VE values (if in open loop) or other detail to give me the desired O2 Values.

Is this the right attitude to use when using this sort of tool?

Pete





98fxstc

Unless things have changed recently , MegalogViewer can not be used with later versions of TTS.
I did talk to Andy about it a couple of years ago, but it seems that changes with TTS upgrades create too much work to maintain compatibility between the two systems.

Fritzables

I typically export the V-Tune data to CSV.
I have never had any success getting MegaLogViewer to read the raw file.