Sprocket Bolts

[cheech]

Tedd Cycle had a kit pn 37-8671 with torx bit to fit

Their site list these as 3/8"-16.

[No Cents]

  when I stated I used 1" long bolts...I meant 1" of the threaded part of the bolt...not counting the bolt head in the length. Using the spacer I needed (which it bolted to the hub) and it had threaded bolt holes for the sprocket, it would only accept a bolt with 1" of threads.

[attach=0,msg1379897]

[cheech]

  when I stated I used 1" long bolts...I meant 1" of the threaded part of the bolt...not counting the bolt head in the length. Using the spacer I needed (which it bolted to the hub) and it had threaded bolt holes for the sprocket, it would only accept a bolt with 1" of threads.

Under head to end of fastener is how most are classified with regard to length. So calling them 1" is correct.
Flat head screws like Ohio posted are measured and classified overall.

[hbkeith]

  when I stated I used 1" long bolts...I meant 1" of the threaded part of the bolt...not counting the bolt head in the length. Using the spacer I needed (which it bolted to the hub) and it had threaded bolt holes for the sprocket, it would only accept a bolt with 1" of threads.

[attach=0,msg1379897]

Yes im talking just threads , im using a raised lip spacer , so the bolt goes thru sprocket and spacer

[xlfan]

Tedd Cycle had a kit pn 37-8671 with torx bit to fit

Their site list these as 3/8"-16.

At least I said 'had' 
[attach=0,msg1380032]

But they weren't 1 3/4" long, they were 1 1/2" long.