R&R Cycles Pro Street Roller Rockers

[Ohio HD]

Anyone here who has personally used the R&R Cycles Pro Street roller rockers? Just looking for any feedback about them after they were used for several miles, good or bad.

[jsachs1]

I rebuilt a R&R engine for a shop 11-16-15. It had a bad set of 124" flywheels. I replaced a fair amount of parts, but not the roller rockers. So, I just checked my build sheet, they passed the test = they were good. "B" engine 38,000 mi.
John

[Ohio HD]

Thank you John. Your endorsement is a gold seal as far as I'm concerned.     

Do you happen to know what cams were under them? just curious.   

[jsachs1]

Thank you John. Your endorsement is a gold seal as far as I'm concerned.     

Do you happen to know what cams were under them? just curious.

124 cu. in. + I went 020" over. R+R 615 cams. I installed new S&S premium lifters.
John

[Ohio HD]

Thank you John. Your endorsement is a gold seal as far as I'm concerned.     

Do you happen to know what cams were under them? just curious.

124 cu. in. + I went 020" over. R+R 615 cams. I installed new S&S premium lifters.
John

Thanks John

[itsafatboy]

ive had them on my 116" with woods 9bg cams nice roller rockers fit better than the SS ones i had before ,  i also use RR 2 piece cam plate setup with external breather love it , bullet proof

if looking for lifters i would call GMR performance steve has some awsome lifters that pressure feed the roller needle bearings and are test proven  he only uses stuff that works , 

[FSG]

i also use RR 2 piece cam plate setup with external breather love it , bullet proof

do you mean the R&R Cycles 2 Piece Cam Cover ?

[itsafatboy]

yes i use that one with a thayer oil pump,