Retaining clip size for lifter...??

[hattitude]

I'll be putting my engine back together in the near future... I was looking over the lifters I have available to use..

S&S Premiums (made in USA), approximately 1K miles
Hylift-Johnson 2313SE (from WFO Larry), approximately 1K miles
Hylift-Johnson 842SE (from WFO Larry), approximately 500 miles

I noticed the retaining clip holding one of the 2313SE lifters is tweaked... I'd like to fix that lifter by replacing the retaining clip...

I looked on McMaster Carr's site, and there are different types, ID, OD, width, thickness for both the ring and the groove.... I had no idea there were so many choices...   

What size/type is that retaining clip..... 

[wfolarry]

Give me your address & I'll send you some.
It's not a standard retainer.

[hattitude]

Give me your address & I'll send you some.
It's not a standard retainer.

Thank you very much, PM sent....

PS- i notice you don't list the 842SE lifters anymore....

Were they discontinued....?

Was there a problem with them?

Thanks again...

[wfolarry]

Give me your address & I'll send you some.
It's not a standard retainer.

Thank you very much, PM sent....

PS- i notice you don't list the 842SE lifters anymore....

Were they discontinued....?

Was there a problem with them?

Thanks again...

No problems they just weren't selling. When I ran out I just discontinued them.