42mm Mikuni jetting question

[Topend]

I am going with a stock 95" HD rebuild with the following exceptions; free flow AC, crane 4tc ignition, 42mm Mikuni carb, Vance & Hines Pro Pipe fitted with 4" Supertrapp Disks and a solid end cap (21 disks now) The Mikuni is jetted as Hippo recommended for his Hippo Build.. 20 pilot jet, 165 main, can't recall & couldn't find anything on the jet for the acc. pump, I am thinking 97 needle jet in the middle slot but need to go in and take a look for sure. Should I change any of the jetting? Old build was 97 cu in, woods 5g cams, 42mm Mikuni, SE Performance heads with larger intake valve, cleaned up, groves, 82cc by Deweys Heads. Same ignition, exhaust, AC.
Thanks in advance

[05FLHTC]

20 pilot, 165 main 97 needle center clip and 50 pump jet is a great place to start. I set the PJ on setting about a dimes width & the off setting flush with the carb top.

[Topend]

O5 thanks