March 28, 2024, 05:34:24 AM

News:

For advertising inquiries or help with registration or other issues, you may contact us by email at help@harleytechtalk.com


checking historic codes

Started by iliketoride9, July 07, 2012, 06:38:59 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

iliketoride9

Any body know how to check historic codes on a 2011 street glide. Service manual has no information I could find. Thanks.

Coyote

ODOMETER SELF-DIAGNOSTICS

1. To enter diagnostic mode press and hold the trip odometer
reset switch while turning the IGN ON.  The Run/Stop switch
should be in Run position.

2. Release the trip odometer reset switch. "diag" will appear
on the odometer display.

3. Press and release the trip odometer reset switch. "PSSPtb"
will appear on the odometer display.

4. PSSPtb indicates the different modules that could display
codes if equipped.

• P - ECM codes
• S - TSM/TSSM/HFSM codes
• SP - Speedometer codes
• t - Tachometer codes
• b - ABS codes

5. Quickly press and release the trip odometer reset switch
to cycle through the letters. The letters will flash as they
are selected.

6. Once the corresponding letter is flashing to the desired
module press and hold the trip odometer reset switch.

7. If no DTCs are present, "none" will appear on display.

8. If any DTCs are stored in the module, either current or
historic, they will appear on the odometer. Quickly pressing
and releasing the trip odometer reset switch will cycle
through the stored DTCs.

NOTE
The ECM will show "no rsp" if the engine stop switch is not in
the RUN position. Verify the engine stop switch is in the RUN
position.


9. If odometer displays "no rsp" then the motorcycle may not
be equipped with the module. If the motorcycle is equipped
with the selected module then go to other modules and
look for applicable communication codes.

10. When all the DTCs have been cycled the odometer will
display "end".

11. To clear all the DTCs in that module press and hold the
trip odometer reset switch. If DTCs are not to be cleared
quickly press and release the trip odometer reset switch.
The part number of the module will be displayed.

12. Press and release the trip odometer reset switch again to
continue to the next module.

13. Turn the IGN OFF to exit diagnostic mode.

roadkingdresser

roadkingdresser

roadkingdresser

can you tell me what po151 codes for. can't seem to find a code list. thanks
roadkingdresser

chaos901

Don't have my list with me, but I believe P0151 is the rear O2 sensor.
"There are only two truly infinite things, the universe and stupidity." AE

roadkingdresser

thanks those were hard to get in probably broke a wire thanks. if you get close to your list would you send it for future reference? thanks again.
roadkingdresser


koko3052

 :up: Thanks for that list! Here's to you :beer:

Chippitt68

👍 funny thing is I found that chasing the exact same code

roadkingdresser

thanks for the help still trying to figure things out.
roadkingdresser

Coyote

Quote from: Chippitt68 on August 21, 2017, 03:55:50 PM
👍 funny thing is I found that chasing the exact same code

What are the mods to your bike? Anything connected to the sensors? The code just means the ecm saw a lean condition for too long. Could be lots of things

Chippitt68

It's fixed. New sensor and code never came back.