Security Code??

[crowgo]

  How can I read the security code on my 2102 Ultra's speedometer? I have the fob and know it has something to do with the ignition switch but can't find my owner's manual to figure it out? 

[Ohio HD]

Follow up to step six if all you want to do is know the code.

To reset the code with a HFSM equipped bike (no button fob), you will:
1 Have your key fob near the bike
2 Set your kill switch to off
3 Quickly turn the ignition switch on, off, on, off, on
4 Immediately press and let go of the left turn signal switch twice (press, let go, press, let go)
5 Press and let go the right signal once
6 Current PIN number will be displayed on odometer
7 Change the PIN by pressing the left signal until the desired number is reached
8 Press the right signal to cycle to the next number and repeat step 7
9 Turn ignition off when 5 digit PIN is satisfactory
NOTE: Steps 3 through 5 must be completed in quick succession of each other.

Now you can have the bike armed, and disarm with the PIN (example PIN will be 25522 in the following steps):
1 Ignition switch to on
2 Immediately press both turn signals at the same time (red key light on you speedometer will flash rapidly if done right)
3 Press and let go the left signal 2 times
4 Press and let go the right signal once
5 Press and let go the left signal 5 times
6 Press and let go the right signal once
7 Repeat for each of the last three numbers of the PIN (left 5 times, right once, left 2 times, right once, left 2 times, right once)
8 Red key on speedo will stop blinking if done right (security has been disarmed)
NOTE: Steps 2 through 7 must be completed in quick succession of each other.

[crowgo]

Thx, got it

[bigfoot5x]

Just FYI: I have a 2013 StreetGlide. My instructions for step 4 were to press and release the left blinker button 3 times instead of 2. So if you can't make it work try 3 instead of 2.