Barnett clutch coil conversion?

[FLTR2008Trike]

Wondering if anyone has installed the Barnett clutch coil conversion setup? If so what are your thoughts?
http://www.barnettclutches.com/coil-spring-conversion-kit-1998-up-hd-big-twins.html

[joe_lyons]

Works great but the last one I did didn't work well with the +1 setup for some reason.  I believe it had to do with the stack up of the plates vs stock.

[FLTR2008Trike]

Hmmm, with the torque of my 124" and the weight of my trike plus myself I wonder if it has enough spring pressure to keep the clutch from slipping??

[joe_lyons]

I would go ahead and get the Barnett scorpion setup with the lockup.  If your gonna do it you might as well over do it.

[Ohio HD]

     Scorpions take licking, and never start slipping....   

[whetsel.m]

I have one with the plus one kevlar on an '08 Fl with a 124". Pulls easy and hooks good.

[05fatboy95]

I run the Barrnet coil conversion and +1 kit with out issues on my 107.

[joe_lyons]

I run the Barrnet coil conversion and +1 kit with out issues on my 107.

Pretty sure it was just bad luck on my behalf.  I still need to measure the stack up and see how it measured to the stock plates.

[05fatboy95]

If I remember right I was told to leave something out with the +1 kit.... Having a slow morning and can't remember what it was.

[joe_lyons]

The judder spring and seat?