Engine stand for an "A" motor

[ambush]

Does anyone have the dimensions for an engine stand for an '03 "A" motor?
I found a drawing in a topic about this but it was for a "B" I guess.

[JBarrettB]

I have a Jims tools stand for an 'A' motor.

JB

[1711tab]

I have a Jims tools stand for an 'A' motor.

JB

I have a HYPERFORMANCE engine stand made by "KOC" what measurements do you need???

[ambush]

Height on each end, length of base, width of flange on front

l          __
l             l
l_______l

[ICANTD55]

Dont have the hang or the picture thing yet.

[attachment removed after 60 days by system]

[Sonny S.]

 

[ICANTD55]

Thanks Sonny   

[ambush]

Thanks for all the pretty pictures and congratulations, you got a stand. But I'm having a bit of trouble scaling the dimensions. You see, my bottom end is out being built (so I can't measure it) and I would like to make me a stand to have ready when it comes back. TIA, Ambush

[ICANTD55]

are you welding it up or are you gonna due something like I did. I fabed it in a couple of hours with a cuting wheel and a grinder when I got my bottom end back from hoban. I can measure the 114 bottom end, I have on the stand tonight when I get home .

[ICANTD55]

This is what the home made one is. I would mark the front holes after you mount the motor to get them correct there off set a bit.
I didn't have a welder at the time i made the other one. If you dont remove the locating dowels you will need two more holes at the bottom backside of the stand. But this should get you going. I will fab one out of 1/4 plate next winter for something to do.
Have fun
Aparently I still dont have the hang of the picture thing yet.LOL




[attachment removed after 60 days by system]

[ambush]

I'll be welding it up tonite. Thanks for the replies guys. Ambush

[1711tab]

Height on each end, length of base, width of flange on front

l          __
l             l
l_______l

I went out to measure and when I came back to this thread I see you've got the measurements needed...