oil leak at stater connection

[nuts4shovels]

Oil dribbles out of connector at bottom.  Have pushed in seems to fit, go for ride leaks again?

Some kind of sealer or what?  thanx

Nuts

[Dennman]

I've used the thinnest amount of black atv silicone on both the reg. & the  alt. connectors when assemblin.Ya might try pullin the ext. reg. connector, cleanin oil residue and then a THIN coat of silicone on the connecter sides.I run a clip ta hold my reg. connection in the cases.

[nuts4shovels]

I have the clip on that holds the connection from coming out, reset it but not good enough i guess.  I am afraid of pulling on the connection from outside the case. I don't want to have to remove outer primary to replug the connection. I will try the ATF.  thanx

nuts

[nuts4shovels]

oops--ATV SILICONE

[Dennman]

If that doesn't solve the leak,make a note ta yourself ta atv the int. stator plug when ya do primary work.If the inside plug has been secured properly ya shouldn't have a problem extractin the reg. plug ,puttin atv on it and reconnectin.

[nuts4shovels]

My real concern was a possible pressure build up in primary forcing oil out.  Engine oil is isolated from primary. I have four other shovels and this has never happened before.

Nuts

[nuts4shovels]

All fixed=silicone.  sometimes you look past the problem ya know.

thanx guys

Nuts

[Dennman]

You shouldn't get a pressure buildup if you have your primary vented.