Can't catch a break

[98fxstc]

I only used that filter after two oil filter changes. I bought it when I used to go to the hp shootouts in Fla. It was good for 3-5hp. One year I lost to Gary Salisbury by 1hp so there you go.

Haven't seen this before

And you if you do it's wrong..

Pumping at about 50 psi uses less than 1/4 horse..

[attach=0]

http://www.engineeringtoolbox.com/pumps-power-d_505.html

You're not gonna get one then  Max ?

[Admiral Akbar]

You're not gonna get one then  Max ?

Nope. Cost too much to toss and too lazy to clean..

[gordonr]

Billy did a prefect job changing the location of the ar pins. 

I snatched a pic of Billy hard at it.






As you can see the ar pin is unsupported on one side so the covers will be tigged and faced off.







Then the machining of the lifters and a little grinding in the tappet covers as the lifters bind on the inside. 

[N-gin]

 

[itsafatboy]

purepower oil filter is nice i run same one, 22 micron, double layer and flows well,

[No Cents]

  looks good Gordon!
nice work Billy!   

Ray

[gordonr]

  looks good Gordon!
nice work Billy!   

Ray

Hey thanks Ray.

[1FSTRK]

It appears you gentlemen have things well under control.
Gordon you'll back to where you left off in no time.

[TorQuePimp]

  lookin good