Twin tec initial settings

[TA63]

Just wrapping up a build for a friend.  98 cubes, woods 6, heads by Kirby with compression at 10-1, S&S carb.  Can anyone suggest some initial settings for the DTT ignition?

[Azgunner]

I ran my 95", 37G cam, 44mm CV, 9.8:1 cr with the Twin Tec at 2 init. & 3 adv.
Always ran good, even in the hot Phx. summers.

[Hossamania]

5/5 is the stock setting. I think I'm at 2/2 or 2/3 like Azgunner, same setup as his with 55g cams. Hell, might even be 1/2 it's been so long.

[jrgreene1968]

Just wrapping up a build for a friend.  98 cubes, woods 6, heads by Kirby with compression at 10-1, S&S carb.  Can anyone suggest some initial settings for the DTT ignition?

I have a similar build.. 98", @10:75.1, s&s 585,s, 45mik, etc. I turned my dtt all over the place, even bought the cable for custom mapping. Ended up going back to stock maps, set at 1 and 2. Bike runs good, no ping even in Tx heat, starts easy, so I left it alone

[TA63]

Thanks guys.

[02roadcling]

Initial 3, slope 4.
Read this when I did my dyno:

http://harleytechtalk.com/htt/index.php/topic,43399.msg449268/topicseen.html#msg449268

   cling

[Hillside Motorcycle]

2/2 and 6000 for starters, is a safe spot.
If "mode" equipped, adjust to multi-spark, semi-similar to an MSD.