HarleyTechTalk

What's the fuel pressure? When was the last time you replaced the fuel filter? Have the wires for the injector plugs been tested for internal breaks? Which base map is in your PV?

You need a wired headset, or the HD WHIM & wireless headset, found here:  LINK

I'm new to all this technology stuff. I just picked up a 2022 limited. When I plug in my iPhone, yes that's new to me too, I get music, maps and text. I cannot get phone calls. I don't plan on talking on the phone much, but I am going to be on the road for a month. If my wife needs to contact me it would be nice. I am also the kind of guy that thinks if it's on their it should work. 

Was considering installing the stock Bendix carb on my 75 FXE using an S&S intake. Anyone ever experience issues with this? Just thought using the S&S intake may be a good idea if I wanted to go to an S&S or other type of carb in the future.

You don't say but with an ETS it sounds as though you have a fuel injected engine. Check the fastener on the grounded wire on the frame backbone up under the rear of the fuel tank. Also, if you installed a 100" kit to your 88", including changing cams and other parts and didn't have it tuned I wouldn't expect it to run any better. In fact, running it like that you may be undoing all your time and money by causing damage to the engine.

No reason to cut dip stick with this HD mod on a cruise drive. 

You cannot see attachments on this board.

Check fluid level on side stand. 

I have never seen a dip stick break on a cruise drive trans except when they are not removed for gear set removal. 

Milled bottom flat and fitted long grip grade 8 bolt.  Marked full on side and sitting upright. You cannot see attachments on this board.

I just did a 100" big bore this winter, started it up and took first ride. Before I tore engine apart the bike was running rough last fall. Thinking it was the ets i replaced it with new and bike runs rough and back fires like crazy! I will check codes on pv. Could it be another sensor? TIA

There r companies that sell Bellville springs. Iirc Bokers. Does anyone have the specs on early twin cam springs ? Size, bevel, and stiffness ?

Great information