HarleyTechTalk

So, here it is a year after this whole thing started. Still having the same problem. I have also changed the MAP sensor. no change. Can't find any bad wires (yet). If it didn't run perfect, maybe I could find something to fix. Any suggestions ?

One guy I know who runs E85 has right around 15.0:1 compression.

Quote from: Ohio HD on April 24, 2024, 01:05:56 PMAs long as there's not a ridge that you can feel it looks to be just normal wear. Did you keep the lifters segregated so that you can look at each roller as compared to each lobe

well some good news at last. yes but i'm hesitant to reuse those lifters. 

It appears that 5/5 % gain is the number talked about in un-boosted apps .
I could see a huge downside would be keeping moisture out of the fuel.
Do you live in a humid climate ?
You would (should) likely need to flush the system with regular gas between rides .

16 hours !!!!!

Where the heck was that book when I was working on flat-rate

I think I could change a 6 speed cassette blindfolded in 6 hours LOL 🤣🤣

~John

Don't know but I changed mine out of a carburetor model electra glide by going at it from the left side.  I remember it being tight but I was able to do it.  I believe the little screw was the biggest challenge not to drop it into oblivion.

As long as there's not a ridge that you can feel it looks to be just normal wear. Did you keep the lifters segregated so that you can look at each roller as compared to each lobe?

here's a better video of the front cam. is it trash?
removed the snap ring and cleaned reassembled and clearance between cam and cam plate is .015

Check if a screw clamp was used on that line. They slowly eat through the rubber. It is supposed to be an Oteker type clamp, not a screw one.

I have replaced a couple of the 63628-00 elbow hoses due to dry cracking, but those were on 15-20 year old bikes.