OK its a shovel post.. but WTF if I dont like it ..Ill remove it.. :smiled:
Im looking for a place to find brushings to fix elongated holes in the mounting points for the one piece dual piston type
[attachment removed after 60 days by system]
Dunno if this is it or not
J&P 08 catalog top of page 685
Caliper mounting bushing, sez for dual disc fork legs 77 to 83, not sure if it'll work on the rear.
Part # 24000892 OEM # 46018-77 46019-77
Anyhow that page has "some" caliper rebuild components.
Mark
Thanx Mark... Im checkin it now
Those are for the small pins in the front ones on a dual caliper system ..Im still looking...LOL
HV,,, would it not be as east as goin to your local machine hop and askin to open up the hole till its a circle,,then have them turn a nice bushing for you...I've had this done a few times for HD and aftermarket stuff.
Dave
Don't think there is anything available for those calipers. Best to do as stroker suggested. Quick, easy and will last forever.
Lew
I have used the 'nanner bushing kit before........one of the aftermarket suppliers sells 'em cheap. Consists of two bushings and two bolts........ya just drill the appropriate size hole and zapp em in...........I since then retired the 'ol nanners to a nail in the sled shed and sprung for performance machine setup (for a round swingarm,I might add)..............best thing I ever dun
those later dual piston calipers are good. I'd fit bronze bushings in it. Machine shop, like stroker800 said. :up: