I am helping out a friend. He has a 2003 Electra Glide, his clutch push rod bearing failed and now has the pushrod gauld up and seized in the trans. Also it broke the release cover. He wants to find a trans at swap meet. Are all the 5 speed gear sets interchangeable between all the models? If so what years?
98-06 touring will interchange
Thanks, so softail and dyna gear sets are different?
Different ratios. Check out this site: http://bigboyzheadporting.com/Gearratio.htm
All the HD stock options are some popular aftermarket transmission sets
MIKE
Quote from: fxstdavew on November 11, 2020, 07:28:03 AM
Thanks, so softail and dyna gear sets are different?
There is no difference between gearsets from one model to another, gear ratio or otherwise.
`91 and later gearsets will interchange.
Replacing the gearset seems a bit drastic, if the mainshaft is damaged, just replace the shaft.
The same mainshaft part number was used from 1991 through 2006.
I had a very slightly used complete gear/cassette set from an '01 Softail that I just had put into my '01 RoadKing. Original set had 115,000 hard miles, the tech said it was in surprisingly good shape, but I had him put the new one in anyway, third gear was a bit crunchy on the old one. New set works nice and smoothe.
That's a rarity - the 5-speed is a work horse.
You can pick them up off flea-bay and other sights pretty affordable. Most people who go to the DD6 or OD6 sell them.
There are also many sites with wrecked bikes that sell whole parts as well. Rebuilding it is a waste of money. The only difference is the Case for Model applications.
If he plans on keeping it and does a lot of touring the drop in six speeds IMO are worth the money.
Quotehis clutch push rod bearing failed
are you meaning the wafer throw out bearing ?
Quotenow has the pushrod gauld up and seized in the trans
take the derby cover off, remove the release plate then knock the pushrod out from the left side
QuoteAlso it broke the release cover
plenty around ..... cheap as chips,
fit a Baker Heavy Duty Throwout Bearing
maybee even a later release ramp(s)
FSG, I tried to remove the push rod that way. I can't even get it apart from either side it welded itself together. We are thinking finding a whole used trans could be cheaper than piecing it together. Just researching the options.
Quote from: Pirsch Fire Wagon on November 11, 2020, 12:58:34 PM
That's a rarity - the 5-speed is a work horse.
Not wanting to hijack this thread, just wanted to clarify, third gear would occasionally "crunch" when shifting, not always, mostly under hard load and hammering for speed. Physically the gear looked fine when disassembled. This bike has been pounded on, and I would have just run it as is, but I got the gear set for free, and was having all my leaks fixed, so figured why not.