1
General / Re: oil filter mess
Last post by JohnCA58 - Today at 06:52:31 AMI have tried all those devices, what works best for me I learned from Tweekmytwin "Jim" laying a diaper below the filter and it absorbs the oil without leaking beyond the diaper.
2
General / Re: Engine sputtering under ac...
Last post by Matty_d - Today at 06:29:28 AMSeems like it may have been a leak in the intake seal. I reseated the throttle body last night and I did not experience the issue this morning.
Added changing the fuel filter to my to do list next.
Added changing the fuel filter to my to do list next.
3
General / Re: oil filter mess
Last post by truckrglenn - Today at 02:04:46 AMI use a piece of cardboard ripped and creased to fit.
4
Pan Head / Re: Show Your Panhead
Last post by JSD - Yesterday at 10:44:10 PMSure looks nice. What heads S&S ?
5
The Welcome Forum (Contact Us) / Re: New Member Saying Hello
Last post by JSD - Yesterday at 06:47:58 PMGday from Australia
6
Pan Head / Re: Show Your Panhead
Last post by Deye76 - Yesterday at 05:38:18 PMechd215, very nice. S&S heads?
7
AFR & Tuning Zone / Re: tts barometric setting
Last post by jpbo - Yesterday at 01:07:09 PMok sounds good thank you very much for advice 
8
AFR & Tuning Zone / Re: tts barometric setting
Last post by rigidthumper - Yesterday at 12:21:32 PMIf you're referring to MAP Normalization Gain table, you need a dyno and a weather station- not worth messing with on the street.
If you are referring to the Minimum TPS for Baro Correction, it's already set for a 107/TTS100 combo in that map, no need to change.
If you are referring to the Minimum TPS for Baro Correction, it's already set for a 107/TTS100 combo in that map, no need to change.
9
General / MOVED: Nightster fork tube len...
Last post by Ohio HD - Yesterday at 10:03:28 AMThis topic has been moved to Source An Item or Vendor.
https://harleytechtalk.com/htt/index.php?topic=121769.0
https://harleytechtalk.com/htt/index.php?topic=121769.0
10
The Welcome Forum (Contact Us) / Re: New Member Saying Hello
Last post by Leed - Yesterday at 09:27:23 AMAnd hello from Texas!