Hi All,
I have a 2017 Fat Boy that has the 110CI Kit installed.
The Cams are SE585.
The Heads are SE CNC Ported.
The Air Cleaner is a K&N Free Flowing type.
Yhe Exhaust is a Rinehart 2-1.
I tune using the Master Tune system.
I have attached a screen dump of two VTune runs, the one on the left is prior to a VTune whilst the one on the right is after I do a datalogger run.
The graphic is showing a hole appearing after a datalogger run is performed, around 40 kPa MAP.
The Front Cylinder is sweet. The issue is only occurring on the Rear Cylinder.
When I look at the O2 values around the area, you can see it going lean.
I am now wondering if I should be increasing the values in the EGR Effect Table for the Rear around the area in an effort to combat the problem??
Pete
[attach=0]
Drifting lean may be reversion, or incorrect O2 depth placement. Verify the sensor is in the exhaust stream- those adaptors sometimes are way too long.
Hey Rigid,
I checked the depth of the Rear & Front O2 Sensor bosses and all is fine in that area.
So, I believe it's a ReVerb issue.
I will bring the values on the EGR Table and see how much it impacts the VE Table.
Pete
Also check for any manifold leaks.
But would a leaking Manifold create such a dip??