Quote from: JSD on March 25, 2024, 09:03:23 PMAlways use koyo full rollerAlways had good results with Torringtons too.
Quote from: jsachs1 on March 26, 2024, 02:04:43 PMIIRC, Mike epoxied the manifold area spacers on the 57 mm Kury throttle bodies. I have that TB on my 05' CVO Electra Glide, and will check. Jims machining sells spacers. Check with them on bolt pattern, and dimensions.
John
Quote from: Shep236 on March 25, 2024, 06:42:09 PMOk thanks. I wanna buy a cheap gutted one to port match to these heads I bought and just swap guts and go when I go to build the top end. An intake manifold from an 11 electra should fit my 09 right?You need to be careful. Some of the later ones were very thin in some areas. I have a some cores, and if I get a chance, I will try to figure out the years of the bad ones.
Quote from: blown alcohol on March 26, 2024, 08:27:03 AMI have found one 442 spacer for sale. How much would it cost to have it duplicated?
Page created in 0.039 seconds with 18 queries.