how do i read codes..
rode the bike last weekend...today i get on it and get ready to go and no left turn signal..works then dont..not the bulb..
and the gas pump on the dash is blinking...
and the red light in the center stays on all the time....
i mean..all it did was sit...im guessing water in a plug maybe? 17 breakout...ill run the codes before i start looking...dangit i hate electrical crap
Check battery voltage and for loose cables. Start simple.
Manual: "To enter diagnostic mode, press and hold the trip odometer reset switch located on the left handlebar controls, while turning the IGN ON."
Karl
i did put it on the charger..batt is 4 yrs old so its likely that..but my dyna did dumb "Potty mouth" when the ginat plug under the seat got wet....
so many things at once tho right? tun signal brake light..just one..intemittent..and the low range gas light blinking...tanks almost full..only 35 mi on it..id..wierd
Have you ridden in heavy rain lately to make you think it is a wet plug? Have you checked for loose battery cables?
washed it since last ride tho