Anyone here who has personally used the R&R Cycles Pro Street roller rockers? Just looking for any feedback about them after they were used for several miles, good or bad.
I rebuilt a R&R engine for a shop 11-16-15. It had a bad set of 124" flywheels. I replaced a fair amount of parts, but not the roller rockers. So, I just checked my build sheet, they passed the test = they were good. :up: "B" engine 38,000 mi.
John
Thank you John. Your endorsement is a gold seal as far as I'm concerned. :up:
Do you happen to know what cams were under them? just curious.
Quote from: Ohio HD on September 24, 2021, 03:33:41 PM
Thank you John. Your endorsement is a gold seal as far as I'm concerned. :up:
Do you happen to know what cams were under them? just curious.
124 cu. in. + I went 020" over. R+R 615 cams. I installed new S&S premium lifters.
John
Quote from: jsachs1 on September 25, 2021, 05:08:44 PM
Quote from: Ohio HD on September 24, 2021, 03:33:41 PM
Thank you John. Your endorsement is a gold seal as far as I'm concerned. :up:
Do you happen to know what cams were under them? just curious.
124 cu. in. + I went 020" over. R+R 615 cams. I installed new S&S premium lifters.
John
Thanks John
ive had them on my 116" with woods 9bg cams nice roller rockers fit better than the SS ones i had before , i also use RR 2 piece cam plate setup with external breather love it , bullet proof
if looking for lifters i would call GMR performance steve has some awsome lifters that pressure feed the roller needle bearings and are test proven he only uses stuff that works ,
Quotei also use RR 2 piece cam plate setup with external breather love it , bullet proof
do you mean the R&R Cycles 2 Piece Cam Cover ?
(https://i.imgur.com/xwHknt3.jpg)
yes i use that one with a thayer oil pump,