New SE Intake manifold

[Txwezl]

I wonder if this flows more evenly than the plastic stock version.
www.harley-davidson.com/store/extreme-flow-55-mm-intake-manifold

[BigT]

I wonder if this flows more evenly than the plastic stock version.
www.harley-davidson.com/store/extreme-flow-55-mm-intake-manifold

Looks like the manifold supplied with the SE 64mm throttle body.

[spunky_man]

looking at the part numbers in the 64mm throttle body kit, these are not the same.

[hd06]

  Nice upgrade to get rid of that plastic intake.

[BigT]

looking at the part numbers in the 64mm throttle body kit, these are not the same.

I've never seen a separate part number for the manifold as it was only available as an assembly with the throttle body

[spunky_man]

this is the the link to the install instructions. scroll to the bottom for part numbers:
https://serviceinfo.harley-davidson.com/sip/service/document/index?reference=-J06346&fullscreen=true&locale=en_US

[BigT]

this is the the link to the install instructions. scroll to the bottom for part numbers:
https://serviceinfo.harley-davidson.com/sip/service/document/index?reference=-J06346&fullscreen=true&locale=en_US

I have the sheet already and as you should see no separate numbers listed for the manifold and throttle body....

[joe_lyons]

Tada not the same.

[spunky_man]

1 Induction module assembly, 64mm Not sold separately
2 Seal, intake manifold (2)                27300087
3 O-ring, injector (lower) (2) (red)     11900074
4 O-ring, injector (upper) (2) (black)  11900073

could not produce the table fully, but take note of item 2. different part number

https://serviceinfo.harley-davidson.com/sip/service/document/index?reference=-J06346&fullscreen=true&locale=en_US

[spunky_man]

https://serviceinfo.harley-davidson.com/sip/service/document/index?reference=-J06633&fullscreen=true&locale=en_US

this is the install instructions for the 55mm throttle body, note item 2

2 Seal, intake manifold     27300164

[Mainecat]

An HD shop has a video where they measure the stock manifold, the SE 64MM and HPI for the M8.  The manifold outlets inside circumference (where they bolt to the heads), were exactly the same on the stock and SE64.  I haven't seen where anyone has measured the new 55mm manifold, but I would guess they saw the numbers Ward got by porting and decided they would get in on it and cheaper, I might add.

[shysterorange]

is the video on youtube? do you have a link?
thanks

[BigT]

 Before and after photos of Ward porting....  [attach=0,msg1281320] 

[shysterorange]

I think this is the video https://www.youtube.com/watch?v=yE4eqismPbs
1.80 on stock and 64 mm

does anyone see any issues with bolting a stock tbody to a 64SE alum manifold? Bolt patterns...would it work?