I am looking at a reproduction Knucklehead project and considering the S&S 93 Knuck motor.
Any of you familiar with it or have experience with it? Comments?
https://www.sscycle.com/products/KN93-Complete-Assembled-OHV-Engine/ (https://www.sscycle.com/products/KN93-Complete-Assembled-OHV-Engine/)
Also, what about frames. Several steering geometry variants are offered by manufacturers. Any comments or suggestions on this?
Just finished a project for a customer replica 1940 used the 93 from S&S very nice will dyno tomorrow for a number run will post
no numbers as the ignition is brake in programed but runs good
Please post some pics
Must have blown up on the dyno! :potstir: