No front brake pressure after lever change

[BCD]

Today I installed new poly riser bushings on my 01 Road King and decided to swap out levers I've had for a long time. The clutch lever went on fine but the after replacing the front brake lever, it has no pressure. Searching for a fix. Thanks!

[Pirsch Fire Wagon]

If the system was not opened I would think the Lever itself may be the issue. Perhaps the Actuator Tab is not making contact with the Plunger?

[Tynker]

Today I installed new poly riser bushings on my 01 Road King and decided to swap out levers I've had for a long time. The clutch lever went on fine but the after replacing the front brake lever, it has no pressure. Searching for a fix. Thanks!

If the rubber seal on the plunger rod is torn, that is your problem.

[Phu Cat]

Try removing the handle again and push the actuator by hand to see if you get pressure that way.  If you do it's the new handle.

PC

[roadkingdresser]

Put the old handle on and see how it acts. should tell you something.

[kd]

Put the old handle on and see how it acts. should tell you something.

And when you have them both in your hands do a real close check for any differences.