So I was told my bike has a 5800 limiter in 6th. Tuned with a super pro tuner, can this rpm be raised?
The rev limit can be set to 7500, but the background software will still chop it off ~155MPH (5800 RPM) in 6th gear.
:pop:
Raising the limit above the 5800 mark could be OK done on an TC "A" motor, but would not be advisable on a TC "B" motor with counter balancers. :potstir:
It is the speed limiter not the rev limiter .
Actually running 5800 RPM and 155 MPH in 6 th gear is only gonna happen on the dyno .
With other tuners you can recalabrate the speedo while on the dyno to make the motor pull to whatever rpm you want . It thinks it is doing say 130 instead of 155 MPH . Therefore it will pull to any RPM you want .
Sepst can't re-cal the speedo , so you can only pull to whatever MPH the speed limiter is set for in that particular cal . There is also a 5 th gear speed limiter that varies from cal to cal .
I wouldn't even spin the tires that fast on a drum when they're only rated to 130 or whatever.
Never had a tire blow out at those speeds. As its only there for less than a sec then back down.
I have a couple of PCVs that I pulled the VVS signal wire from so that I can just quickly plug it in place and run the rpms up to 6200 with out issues.