Happy as in accurate. Every once in a while I pop the calibration plate on to see how it's doing. I think it's spot on. While I don't usually give out flow sheets I know that if my heads go on anybody else's bench the #'s are good. No ifs ands or buts.
[smg id=2704] [smg id=2703]
:up:
Keep her happy...... :wink:
:up: sure helps with the Technical Audit :SM:
Quote from: wfolarry on March 17, 2016, 03:07:21 PM
Happy as in accurate. Every once in a while I pop the calibration plate on to see how it's doing. I think it's spot on. While I don't usually give out flow sheets I know that if my heads go on anybody else's bench the #'s are good. No ifs ands or buts.
[smg id=2704] [smg id=2703]
It sure woke my bike up! :up:
I know I'm a happy customer!
I've got another set of 110 heads for you to massage. I'm in no real hurry but when would be a good time to ship them to you?
Since you're not in a hurry ship them whenever it's convenient for you.
Larry,
What's the diameter of the hole? Is the plate sheet metal (0.060) or thicker?
The hole measures 2.045
It's 1/8" thick with a taper cut on the backside for a sharp edge orifice.
[smg id=2753]
:up: :up:
Thanks Larry..
I couldn't be happier with the work Larry did for me!!!!
I made a copy of this plate but screwed up slightly and the hole end up at 2.050.. Using my calibration plate, the plate I made flowed 302.4 cfm when corrected to 28 inches (really flowed 176.1 at 9.5 inches).. The hole area difference is only about 0.5 %..... If I correct for that I get 301 cfm.. I'd say that is a good plate to cal by.. About 0.3% difference..
I've got 3 plates of different size holes for calibrating.
If you want I could send them you you & you can check/compare.
Quote from: wfolarry on June 07, 2016, 03:48:30 PM
I've got 3 plates of different size holes for calibrating.
If you want I could send them you you & you can check/compare.
Sounds like a good idea.. I'd like to test them fer sure.. I would like to hold off for a few weeks tho.. After being off grid for almost 19 years, I'm getting a connection to SDG&E.. Part of the project includes power to my shop.. Would like to do it then as power will more stable than what I can get with a generator.. :teeth:
Just let me know when & I'll send them your way.