HarleyTechTalk

Technical Forums => General => Topic started by: Reddog74usa on September 15, 2020, 08:24:35 AM

Title: Drago 2-1
Post by: Reddog74usa on September 15, 2020, 08:24:35 AM
I'm lookin at a Drago 2-1 for my 14 FXDC. Any thoughts as in low end mid range power and sound? The quality of the pipe looks top notch.
Title: Re: Drago 2-1
Post by: NHBagger on September 15, 2020, 04:21:05 PM
Had one on my 01 Bagger with a 106 motor. I liked the sound and it seemed to perform fairly well. I think it went 120/110.
Title: Re: Drago 2-1
Post by: phillyfan on September 15, 2020, 05:51:08 PM
I have one on my '09 RG with a 106. I like it a lot. Quiet cruising, love the sound when on the gas
Title: Re: Drago 2-1
Post by: Tommy D on September 15, 2020, 06:52:17 PM
Quote from: Reddog74usa on September 15, 2020, 08:24:35 AM
I'm lookin at a Drago 2-1 for my 14 FXDC. Any thoughts as in low end mid range power and sound? The quality of the pipe looks top notch.

Frank did nice work with the Dragula 2
Solid performer
Title: Re: Drago 2-1
Post by: tommy g on September 15, 2020, 07:18:48 PM
Only slightly less power than my Fat Cat. Well made and good sounding.
Title: Re: Drago 2-1
Post by: kd on September 15, 2020, 07:29:50 PM
Frank told me that it was comparible to my Dragula 1 and the Dragula pipe is a killer easily handling 150's
Title: Re: Drago 2-1
Post by: Hossamania on September 15, 2020, 07:37:53 PM
Is it too big for a 95"?
Title: Re: Drago 2-1
Post by: kd on September 15, 2020, 07:42:05 PM
There are diffent baffle sizes offered.  I'm using a 2.55" on my 120 at 145 tq / 149hp.
Title: Re: Drago 2-1
Post by: Reddog74usa on September 15, 2020, 07:59:50 PM
It's a 103 but no biggie as i heard from Frank and he said they don't make a pipe for a FXD so the person selling me this pipe has mounted a 2-1 on a Dyna with some fab work. I already have a nice set of take off exhaust header pipes from an 08 FXD with the 18mm bungs so I may just go that route with a set of Cycle Shack slip on's I've had on the shelf and call it good. I'm only doing a CR 570-2 cams with a high flow ac and power vision with target tune. I didn't see any pipes listed for a dyna on his site so I thought I should ask him about that and glad I did.