VE question.

[Merc1100sc]

I thought I remember reading sometime ago that you wanted to adjust cubic inches, CLB's, and so on to attempt to obtain 100%, or closest to, in all cells of the VE table. Is this true, or are you just making adjustments (using the TTS) to get all cells in the V-Tune VE tables as close to white as possible, regardless of what the numbers are?

Thanks.

[Don D]

If they are trending near max (127?) you will need to change the constant of Inj size or engine size. if most are in the 70+ to 100 you are fine.

[VDeuce]

How about if perhaps say 5 or 6 cells are maxed, should you then up the engine size? I believe 5% up and then lower the VEs by 5% is what was recommended.

I did this last night as I had 5 or so cells maxed.

[Steve Cole]

You do not want any cells maxed out. I like to finish a custom tune with the cells at 120 or less as this leaves just a little adjustment left in the calibration once your finished.

[Merc1100sc]

Thanks Don.