TPS Voltage - New Throttle Body

[VDeuce]

I just installed a HP Inc 51mm throttle body on my 107 and am wondering about the TPS voltage. I have the SERT so I can tell what it is set to, and I have it adjusted to .35V. Is this correct?

This is for the stock ECM on an '07 Street Glide.

I will be using the TTS Master Tune for initial tweaking and eventually a dyno tune.

[Airglider]

With the DTT system, the recommendation is for .4v with the ignition on but not running.

Ag

[nc-renegade]

You should be okay.  According to the manual it should be:

●At idle (closed throttle), the signal is typically in the range
of 0.20-0.80 volts.
●At wide open throttle, the signal is normally 4.0-4.9 volts.

[VDeuce]

Ok, thanks! I thought with the TCFI setup they wanted .35, so that's where I set it. I could adjust it if need be, but then again, this is for the stock ECM and will use Master Tune.