UPDATE

[53Pan66shovel]

ok i put the new clutch bearing in clutch is reasling good no more stalling out the rod adjustement screw seems to be sticking out farther than before when u pull the clutch in it hits the derby cover also when u kick it around the primary chain is tight than u kick it around again its loose? makes no sence last but not least the clutch is making more noise than before im in need of so HELP HERE!!!! thanks

[stroker800]

  If you have a chain(primary or drive) that will have a slack and then a tight spot this is  a bent shaft as far as adjuster sticking out too far,,,dismantle and reassemble...double check to manual.
Dave

[wreck74]

there are four different size pushrods.




[attachment removed after 60 days by system]

[CraigArizona85248]

A chain with a tight spot does not always indicate a bent shaft.  More often it is simply a worn out chain and sprockets.  If that is the case you need to replace the chain and the sprockets.  You don't want to put a new chain on old sprockets.  That's a sure way to wear it out super fast.

-Craig

[53Pan66shovel]

i think im gonna modify the adjustment screw so u think the squealing might be the chain or something im kinda confused