REPRINT FROM OLD HTT: How to erase a stored code?

[ClassicRider2002]

DISCLAIMER: THIS IS A REPRINT TOPIC FROM "OLD" HTT

I have saved many great topical discussions as "links" over the years and would hate to see these lost, so I am reprinting this TOPIC here, which may "perhaps" help some.


TOPIC: How To Erase A Stored Code  06-28-07


From: PanDan9067  (Original Message) Sent: 6/28/2007 7:37 PM                        Message 1 of 4 in Discussion 
'02 Ultra.
I was trying to start the bike with a low battery and it stored a trouble code. I've tried disconnecting the battery and the code persists. I would like to erase it so that if there ever is a trouble code, I'll know it. Thanks in advance.
Dan.

[ClassicRider2002]

 

From: fbnent Sent: 6/28/2007 8:14 PM                                                           Message 2 of 4 in Discussion 
I believe it will go away in 50 starts or you can go to someone with the machine to do it.  R.


From: _ToBeFrank_ Sent: 6/28/2007 9:29 PM                                                   Message 3 of 4 in Discussion 
Here's the procedure on my '03:

Leave run-off switch in off.
Turn ignition switch 3 times, on-off-on-off-on (leave on)
Hit left turn signal twice - you'll get two flashes
Hit right turn signal once - one flash
Hit right turn signal once - two flashes
Hit right turn signal once - three flashes
Hit left turn signal once - the stored codes will start flashing
Hold left turn signal down until you get two flashes - codes are cleared.

Don't ask why I have this memorized.

Messgage 4 offered no further insight....


Anything added beyond this point is new information.

Regards,

"Classic"