intake port

-JC-1 · August 31, 2009, 06:42:22 PM

am I getting some oil blowby past the guides?-or maybe past the rings?- normal? - just looking for a little advise- trying to understand what i'm looking at-
TIA
joe

PanHeadRed · September 01, 2009, 04:12:46 AM

Are your breathers going back into the intake?

Nice port.

-JC-1 · September 01, 2009, 05:18:51 AM

Yes- S&S head-124"- Baisley street port- very nice

Deye76 · September 01, 2009, 05:38:48 AM

Run some seafoam in your fuel tank very now and then,
mist seafoam through the intake couple times a season.

PanHeadRed · September 01, 2009, 05:43:26 AM

>Yes<

Re-rout them to atmosphere.

Barrett · September 01, 2009, 10:18:37 AM

That's a good picture, I've been looking for a mild port job and nobody shows their work, you would think they would post some pics like that.

-JC-1 · September 01, 2009, 12:13:57 PM

Quote from: Barrett on September 01, 2009, 10:18:37 AM
That's a good picture, I've been looking for a mild port job and nobody shows their work, you would think they would post some pics like that.

Baisley has ported heads on 2 motors for me- have always been very happy with the results- I would use Dan again-

Hope I didn't cross any line by posting the pic

Pushrod · September 01, 2009, 02:41:13 PM

If you post a pic of the exhaust port i can tell you you have nice ports

larluvssandra · September 01, 2009, 03:11:47 PM

I'd say valve guilde seal. Have you gat a ping problem? Larry

HarleyTechTalk

News:

intake port

-JC-1

August 31, 2009, 06:42:22 PM Last Edit: August 31, 2009, 07:26:34 PM by -JC-1

PanHeadRed

September 01, 2009, 04:12:46 AM #1

-JC-1

September 01, 2009, 05:18:51 AM #2 Last Edit: September 01, 2009, 12:17:02 PM by -JC-1

Deye76

September 01, 2009, 05:38:48 AM #3

PanHeadRed

September 01, 2009, 05:43:26 AM #4

Barrett

September 01, 2009, 10:18:37 AM #5

-JC-1

September 01, 2009, 12:13:57 PM #6

Pushrod

September 01, 2009, 02:41:13 PM #7

larluvssandra

September 01, 2009, 03:11:47 PM #8