adjust . thanks for any helpsteering head bearing, 06 road glide

[jimbohand]

the Harley tech manual, says to remove the instrument bezel, loosen pinch bolts, Loosen fork stem nut, fasion a bearing adjuster tool, to adjust.  It dosen"t show where the tool goes, do I need to remove the instrment nacelle as well? I am getting a clunk and have to tighten it

[06roadglide]

Remove the 2 screws holding the speedo/tach in place and set it aside.  Loosen the big nut on top of the triple tree stem.  Loosen the the 2 pinch bolts on the lower triple tree, 1 on each side.  Here's were it gets tricky. Turn the bars to the right or left and look under the upper triple tree and you'll see the adjustment nut,  NOT a hex nut but a nut cut to almost look like a gear.  Turn that to set your "fall away". 
It can be tricky on a RG because it's tough to see.

[Yo J]

How do you know if the steering head bearings are adjusted correctly. Manual sez that the front end from full lock left should swing right then left and then make a " partial third swing " back right.

How much on that third swing back right?  1" 2"  or 10, 11, 12,  1, O'Clock looking at wheel from behind handle bars?