Just finished dyno tuning my 95 inch 2004 softail 570 G cams (update)

[ΚĜΗΟŜΤ]

Just finished dyno tuning my 95 inch 2004 softail 570 G cams
Results are in the dyno section

88.2 hp
103.9 torque

opinions and comments are welcome.

http://harleytechtalk.com/htt/index.php/topic,38292.0.html

Jack

[ΚĜΗΟŜΤ]

Well I was not satisfied with my tune and felt something was not right!

Here is a update...

UPDATE,

With the help of 05FLHTC and installing the dtt software. We determined there was a canned map in the (used) module and a software toggle was selected that did not allow the slope function (dial) to work.

So all that was done at the dyno session was to over jet the carb, The intial was adjsuted but only added a couple of degrees advance to the table cells in the map but did not shift that timing change to a different rpm range.

I thank greg again for helping thru this!!!!

Now to see if the "dyno Guy" will work with me to redo this tune session.................