Installed isolated ignition module/now what do I do with the Bank Angle Sensor?

[Logrhed]

I have an 03 XLH 1200.   I just changed out the ignition to an Ultra Single Fire/  the ignition is made by Dynatech and is totaly isolated.  I hard wired it from the kill and Start switch.  The Bank Angle Sensor has been my problem for a long time now... burning out coils and modules.. it takes on 12 volts form the fusebox and on the backside reduces it to 5V.  Since the bike will still turn over without the BAS even being plugged in the ignition works fine without it the way its now wired.  I have also dumped it more than ehhhhhh once and it has never shut the bike down.  I have always had to go for the ignition or the Killswitch anyway.   

I would like to find a 12v BAS to replace the stock one if I can find one that puts out 12v on the backside.  then I could use that to interupt the feed to the killswitch at the main fuseblock and it will operate properly and shut the bike down if dumped or hit.  Otherwise the BAS is just another useless piece of junk on my bike I need to remove

Any suggestions out there would be greatly appreciated