Steve Cole... VE Table creations

[Blackbaggr]

Did I read somewhere that after the 2nd Vtune process, when you are creating the final corrected calibration and you are projecting numbers into the blank cells on the VE table.... that you "+2" to the last good generated value ??

...I thought I read that in a post by you but now I can't locate it. If that is true, that is not in Doc's guide. I also can't find where it explains this or Doc's method in the TTS help files...

Thanks in advance for you help!!

[Steve Cole]

That is not what I said. What I said to do was look at the last good value for that RPM point that V-tune showed it had corrected properly. Then look at the cells at the lower throttle setting and see what the trend was. If it was going up by say "+2" then you could follow that trend. Just the same is the trend was flat you will just use the same value over again. You need to look at it and make a decision based on what you see. The truth is that if you use the last corrected value that was done at high load and just used it over you will be close enough.

[Blackbaggr]

Thanks Steve..'preciate you getting back so quickly !