Lifter Gone Bad? (120")

[Eglider05]

You gain a tighter fit at the cost of going from a lifter thst is high quality,  decent to one that is less. I wouldn't.

Then I'll stick with the SnS. Now if we could just get SnS to make an oversize.........

Rick

[Ohio HD]

Then I'll stick with the SnS. Now if we could just get SnS to make an oversize.........

Rick

Not likely, they sell engine cases.   

[Don D]

Be sure to check the pin fit while you are in there.

[clawdog60]

What was the consensus for AR pin to lifter clearance?  .001~.0015?

[rbabos]

What was the consensus for AR pin to lifter clearance?  .001~.0015?

That's too tight in my view if you are talking about a bore that has .002-.0025 clearance on the lifter. .003 would be a more civilized minimum.
Ron

[clawdog60]

Thanks,
Noted.

[Eglider05]

Be sure to check the pin fit while you are in there.

.005, I have the +2's on the way.

Thanks,
Rick

[clawdog60]