Winn pep 8 update

[HD/Wrench]

It came out 2 days ago.. New features the graph is layout changed you will need to later that. But in the tach pick up section check the box for load based on engine NOT RPM .. Other wise the brake is all over the board. and now the brake may need some PID adjustment as well .

Brake seems to lag now and not as aggressive. It was over shooting by 250-350 rpm..

[hdbikedoc]

did you figure out the pid's ?

[HD/Wrench]

Yes I did I had to run the numbers a bit , each dyno will vary . I feel its due to the power ( voltage + amps) that you may or may not have. But I could be wrong . Then again I tune a ton of big builds so stockers I have to reset to almost ,..some time less than the STD  PID

[BVHOG]

so has the latest update eliminated the various correction factors?